Posted 15 February 2013 - 11:27 AM
Posted 16 February 2013 - 11:28 AM
some info from someone that does rewinding of these motors he has advised me that he uses 0.15mm cable for big motors.
Posted 27 February 2013 - 07:49 PM
looks interesting might try this later I have a few motors that I could try this on, just not sure if i can get a hold of the needle ??
Posted 27 February 2013 - 09:50 PM
I have to try this yet but managed to get a needle to make it easier to rewind, just not sure what motors to do yet ?
Posted 01 March 2013 - 11:42 AM
Posted 01 March 2013 - 12:47 PM
Nice, this shall help me a lot when I begin the winding process.
Thanks just came across this as well
not sure when or what the cost is going to be yet ??
Posted 20 March 2013 - 10:15 PM
Here is my rough and ready gimbal motor rewire video
Posted 21 March 2013 - 09:42 AM
Thank for sharing Coyote very helpful and I'm sure the members will use it as a guide
Posted 22 March 2013 - 05:32 PM
well RC timer does it again, ordered these last week and the tracking said they were on there was to the USA but no they turned up here today, so I know what im going to be trying at the weekend
Yes rewinding these and see how I get on with them, will keep you posted on what I get ohms wise! and how many turns.
Posted 24 March 2013 - 08:51 PM
I had some spare time tonight so i thought I would try to strip one of these 5010/14 motors, I must say I really do like the look of them anyway to the dismantling of the motor. First I removed the circlip not easy sometimes as I have had bad experiences with these little buggers before, the circlip flying off into the unknown. This time I am glad to say that with a small screwdriver it came of no problem . there are a few wires with a bit of small heat shrink on them that are soldered when you remove this split the wires and you can start to unwind one at a time does not take long just be careful that you dont chip the coating on the stators and you should end up with this
ONLY 3 more to do!!
now I have a habit of losing small things so I put the circlip on the motor casing with the magnets as seen here so I dont lose it
next job is to start rewinding them, I have got some 0.15 wire that I am going to use and hoping for about 15 Ohms with 250 winds ? but will have to test and see, will post my findings here
Posted 26 March 2013 - 09:47 AM
had some time to try out re winding a motors lats night and boy its hard on the finders but after 2 attempts (lost count once) I managed the 1st phase
checked it and with the 0.15 wire wound 200 times it comes in at 19 Ohms which is OK so will continue with the rest later and show results here.
0 members, 0 guests, 0 anonymous users